181195103
952-564-9118
2100 W 98th St, Bloomington, MN 55431

Posts tagged with: Wood Cabinets

MCC Semi Custom Kitchen and Bath Cabinets maintain a high quality standard, at an affordable price.

MCC Semi Custom Cabinets are solid wood with plywood boxes, stained in the inside to match the exterior. We do not use a particle board in our cabinetry. Our drawers are solid wood, dovetail drawer, with full extension heavy duty glides and soft close hinge. You have the option of 6 way adjustable hinges. Our sizes may vary in terms of width, but there are set standards for the heights and depths to ensure that your cabinets are functional.

 

How to measure your kitchen for the MCC Cabinets

 

  1. Begin by measuring the room wall-to-wall. (You will be recording all measurements in INCHES. (EX: 98″, not 8′ 2″)
  2. Make a rough drawing of the shape of the room. Represent each wall, door, window and any protrusions or recessed areas. This plan does NOT need to be ‘to scale’.
  3. Measure each wall section and record on the drawing. (A wall section is from one corner to a door way or window.) Measure each window and door and record. NOTE: Measure Windows and doors from outside edge to outside edge of casing or trim.
  4. Add up all dimensions on each wall and verify that the total is equal to the total wall dimension listed on the chart. (If not, re-measure!)
  5. Locate the centerline of the sink, by measuring from one corner of the wall. Record this dimension on your rough drawing.
  6. Measure from floor to ceiling at several locations. Record the smallest dimension in the body of the rough plan. (For vaulted ceilings, record smallest dimension at the point it occurs on the floor plan and record the greatest dimension at the point it occurs on the floor plan.)
  7. If your kitchen has soffits (also known as bulkheads), measure their height and depth. Using a red pencil, indicate soffit location with dotted line. Record dimensions. (If you plan to remove or replace soffits, skip this step.)
  8. Using a symbol, indicate location of each electrical outlet, switch or light fixture. Indicate the height from the floor and distance to nearest corner.

 

We will provide an estimate and free design  in 24 hours.

We will deliver your MCC Semi Custom Cabinets 15- 20 business days after the order has been placed.

Continue Reading →

How To Clean Wood Kitchen Cabinets?

To minimize any damage to your cabinets associated with the effects of grease, moisture and food spills associated with normal household work, your cabinets should be treated as you would treat fine furniture.

Minneapolis Contractor’s Choice-MCC recommends that you to follow these simple steps to care for your cabinetry:

Solid Wood, Aluminum, Thermofoil, Eurotek, Melamine, Aluminum Cabinetry

Clean cabinets using a soft, damp cloth (not a paper towel) and a mild, non-detergent soap (just a few drops of liquid dish soap in a your cleaning pail of warm water will work). Make sure to dry the cabinets immediately. Do not wax, polish or use abrasive cleansers. Don’t spay cleaner directly on your cabinet and don’t leave damp cloths over cabinets, as moisture can damage the finish.

Wood and Eurotek Cabinetry

The hard, catalyzed varnish protecting your cabinets is intended to resist foods, beverages and household agents normally found in today’s homes.

Thermofoil Cabinetry

Thermofoil cabinets are durable, but can be damaged by excessive heat. You need to make sure your installer properly installs heat shields/panels to protect cabinets adjacent to ovens, dishwashers and ranges.

It is a good precaution to open doors and drawers away from oven during self –cleaning cycles; the high-temperature will damage your cabinets. Damage caused by heat will not be covered under warranty.

Stainless Steel Cabinetry

Stainless Steel Cabinet doors should be cleaned using a soft cloth and a stainless steel cleaner.

 Ultralux Cabinetry

Ultralux cabinets are covered with a film from the manufacturer to protect the high- gloss surfaces. Remove the film after your cabinets are installed. Use a microfiber cloth or other very soft cloth with a non-abrasive soap or detergent.

For more information about our cabinets, please contact us and one of our professionals will be happy to assist you.

Call 952.564.9118 or Visit Us at 2100 W 98th St, Bloomington, MN 55431

Continue Reading →
Minneapolis Contractor's Choice-MCC